User`s manual

SuperH Family E10A-USB Emulator Section 6 Tutorial
R20UT0870EJ1000 Rev. 10.00 Page 194 of 292
Aug 10, 2012
6.9 Executing the Program
Execute the program as described in the following:
 To execute the program, select [Go] from the [Debug] menu, or click the [Go] button on the
toolbar.
Figure 6.10 [Go] Button
When the program execution is started, ‘**RUNNING’ is displayed on the status bar, and then
the executed PC address is displayed in the products that support the CPU status acquisition
function. The program will be executed up to the breakpoint that has been set, and an arrow will
be displayed in the [S/W breakpoint] column to show the position that the program has halted,
with the message [BREAKPOINT] in the status bar.
Notes: 1. When the source file is displayed after a break, a path of the source file may be
inquired. The location of the source file is as follows:
<Drive where the OS has been installed>:
\WorkSpace\Tutorial\E10A-USB\xxxx\Tutorial\source.
Here, ‘xxxx’ means the target product group.
2. If program execution is failed, select [Reset CPU] from the [Debug] menu, reset the
device, and restart the procedure from figure 6.8.