User`s manual

SuperH Family E10A-USB Emulator Section 6 Tutorial
R20UT0870EJ1000 Rev. 10.00 Page 186 of 292
Aug 10, 2012
Note: The items that can be set in this dialog box differ according to the product. For details on
the settings for each product, refer to the online help.
 Click the [OK] button to set a configuration.
6.5 Checking the Operation of the Target Memory for Downloading
Check that the destination memory area for downloading is operating correctly.
When the destination memory is SDRAM or DRAM, a register in the bus controller of the device
must be set before downloading. Set the bus controller correctly in the [IO] window according to
the memory type to be used.
When the required settings, such as the settings for the bus controller, have been completed,
display and edit the contents of the destination memory in the [Memory] window to check that the
memory is operating correctly.
Note: The above way of checking the operation of memory may be inadequate. It is
recommended that a program for checking the memory be created.
 Select [Memory…] from the [CPU] submenu of the [View] menu and enter H’00000000
and H’000000FF in the [Begin] and [End] edit boxes, respectively.
Figure 6.2 [Display Address] Dialog Box
 Click the [OK] button. The [Memory] window is displayed and shows the specified memory
area.