User`s manual

SuperH Family E10A-USB Emulator Section 5 Debugging
R20UT0870EJ1000 Rev. 10.00 Page 179 of 292
Aug 10, 2012
Select [Renesas E-Series USB Driver] from the [Driver] drop-down list box and open the
[Channel] drop-down list box. Channel information for two emulators is displayed in the
[Channel] drop-down list box as shown in figure 5.50.
Figure 5.50 [Driver Details] Dialog Box (2)
Information displayed in figure 5.50 is the information of the USB connector to which the
emulators are connected.
Note: The displayed character strings of the information differ according to the host computer’s
environment.
Check which of the character strings of information show emulators.
Select [<no driver selected>] in the [Driver] drop-down list box and disconnect one emulator from
the USB connector. After that, select [Renesas E-Series USB Driver] in the [Driver] drop-down
list box. Only information on the USB connector that the emulator is connected to is displayed in
the [Channel] drop-down list box.
The above procedures are used to discern which of the emulators are indicated by the displayed
character strings of information in the [Channel] drop-down list box.