User`s manual

SuperH Family E10A-USB Emulator Section 1 Overview
R20UT0870EJ1000 Rev. 10.00 Page 1 of 292
Aug 10, 2012
Section 1 Overview
The E10A-USB emulator (hereafter referred to as the emulator) is a support tool for developing
application systems to run on Renesas original microcomputers.
The main unit of the emulator is connected, through the dedicated debugging interface, to the user
system. The user system can be debugged under the conditions similar to the actual application
conditions. The emulator enables debugging anywhere indoors or out. The host computer for
controlling the emulator must be an IBM PC compatible machine with USB 1.1/2.0 (Full-Speed).
Figure 1.1 shows the configuration of a system where the emulator is in use.
ACT
R
ENESAS
USB I/F
E10A
USB
Host computer (with USB interface)
E10A-USB emulator
USB cable (1.5 m)
Connected to
the USB connector
Connected to
the USB connector
High-performance
Embedded Workshop
CD-R
User system interface cable
User system
User system connector
Figure 1.1 System Configuration with the Emulator