User`s manual

SuperH Family E10A-USB Emulator Section 5 Debugging
R20UT0870EJ1000 Rev. 10.00 Page 154 of 292
Aug 10, 2012
Filtering conditions can be changed several times to analyze data because the content of the trace
buffer is not changed by filtering.
(1) [General] page
Set the range for filtering.
Figure 5.30 [Trace Filter] Dialog Box ([General] Page)
[Don't care other pages]: Only selects the cycle number when this box is checked. Other options
become invalid.
[Enable Filter]: Enables the filter when this box is checked.
[Not designation]: Filters information that does not match the conditions set in those pages
when this box is checked.
[Trace display range]: Sets the range for filtering.
[Start PTR]: Enters a PTR value to start filtering.
[End PTR]: Enters a PTR value to end filtering.
Note: Along with setting the range for filtering, PTR values to start and end filtering can be set
in the [Start PTR] and [End PTR] options, respectively.