User`s manual

SuperH Family E10A-USB Emulator Section 5 Debugging
R20UT0870EJ1000 Rev. 10.00 Page 145 of 292
Aug 10, 2012
5.6.4 Searching for a Trace Record
Use the [Trace Find] dialog box to search for a trace record. To open this dialog box, choose
[Find...] from the popup menu.
The [Trace Find] dialog box has the following options:
Table 5.2 [Trace Find] Dialog Box Pages
Page Description
[General] Sets the range for searching.
[Address] Sets an address condition.
[Data] Sets a data condition.
[Type] Selects the type of trace information.
[Bus] Selects the type of a bus.
[R/W] Selects the type of access cycles.
Note: Items other than [General] and [Address] vary according to the emulator in use. For details,
refer to the online help.
Clicking the [OK] button after setting conditions in those pages stores the settings and starts
searching. Clicking the [Cancel] button closes this dialog box without setting conditions.
When a trace record that matches the search conditions is found, the line for the trace record will
be highlighted. When no matching trace record is found, a message dialog box will appear.
Only the trace information that satisfies all the conditions set in above pages will be searched.
If a search operation is successful, selecting [Find Next] from the popup menu will move to the
next found item.