User`s manual

SuperH Family E10A-USB Emulator Section 5 Debugging
R20UT0870EJ1000 Rev. 10.00 Page 143 of 292
Aug 10, 2012
This dialog box is used to specify conditions for the acquisition of trace information. For a
description of the conditions for trace acquisition, refer to section 2.2.2, AUD Trace Functions.
[Channel A]: Enables channel A of the window trace.
[Bus state] Selects a bus for trace acquisition.
[Read/Write] Sets tracing of read or write access or both.
[Trace start address] Sets an address range for the tracing of data access. The start
address is set here.
[Trace end address] Sets an address range for the tracing of data access. The end
address is set here.
[Channel B]: Enables channel B of the window trace.
[Bus state] Selects a bus for trace acquisition.
[Read/Write] Sets tracing of read or write access or both.
[Trace start address] Sets an address range for the tracing of data access. The start
address is set here.
[Trace end address] Sets an address range for the tracing of data access. The end
address is set here.