User`s manual

SuperH Family E10A-USB Emulator Section 5 Debugging
R20UT0870EJ1000 Rev. 10.00 Page 141 of 292
Aug 10, 2012
[Trace type]: Selects the type of trace function.
[AUD function] Uses the AUD trace function.
[Internal trace] Uses the internal trace function.
[User Memory trace] Uses the memory output function of trace data.
[Trace Mode 1]: An option to determine the operation when the trace information is
continuously generated; only available when selecting [AUD trace] or
[User Memory trace].
[Realtime trace] Some of the trace information will not be output.
[Non realtime trace] Where necessary, the CPU waits until each item of trace
information has been output.
[Trace mode 2]: An option that determines the operation when the trace buffer of the
emulator becomes full; only available when selecting [AUD trace] or [User
Memory trace].
[Trace continue] The oldest trace information is overwritten by the latest
information.
[Trace stop] Previous trace information is not acquired.
[AUD Mode]: Some devices to be debugged can select the 8-bit mode of the AUD pin.
For details on the specifications of each product, refer to the additional
document, Supplementary Information on Using the SHxxxx, or the online
help. This is only available when [AUD trace] is selected.
[AUD trace display range]: An option to set the display range of the [Trace] window; this is
only available when [AUD trace] is selected.
[Start pointer] The trace is displayed from the specified value.
[End pointer] The trace is displayed to the specified value.
[User Memory area]: An option to set the display range of the [Trace] window; this is only
available when [User Memory trace] is selected.
[Start] Specifies the start address of the memory range that the trace
result is written to.
[End address] Specifies the end address of the memory range that the trace
result is written to.