User`s manual

SuperH Family E10A-USB Emulator Section 5 Debugging
R20UT0870EJ1000 Rev. 10.00 Page 139 of 292
Aug 10, 2012
[AUD mode]: Sets the acquisition mode of the AUD trace.
[AUD mode 1]: An option to determine the operation when the trace information is
continuously generated.
[Realtime trace] Some of the trace information will not be output.
[Non realtime trace] Where necessary, the CPU waits until each item of trace
information has been output.
[AUD mode 2]: An option that determines the operation when the trace buffer of the
emulator becomes full.
[Trace continue] The oldest trace information is overwritten by the latest
information.
[Trace stop] Trace information is not acquired after the buffer has been filled.
[AUD trace display range]: Set the display range of the [Trace] window.
[Start pointer] The trace is displayed from the specified value.
[End pointer] The trace is displayed to the specified value.
Clicking the [OK] button stores the settings. Clicking the [Cancel] button closes this dialog box
without modifying the settings.