User`s manual

SuperH Family E10A-USB Emulator Section 5 Debugging
R20UT0870EJ1000 Rev. 10.00 Page 131 of 292
Aug 10, 2012
5.5.19 Go to Source
Only enabled when one event channel is selected. Opens the [Source] window at address of event
channel.
If an address value has not been set to the event channel, this option cannot be used.
5.5.20 [Combination action(Sequential PtoP)]
Sets a sequential condition of event channels or points where performance measurement or
internal tracing starts and stops.
5.5.21 Editing Event Conditions
Handlings for settings other than PC breakpoints and event conditions are common. The following
describes examples of such handling.
5.5.22 Modifying Event Conditions
Select an event condition to be modified, and choose [Edit...] from the popup menu to open the
dialog box for the event, which allows the user to modify the event conditions. The [Edit...] menu
is only available when one event condition is selected.
5.5.23 Enabling Event Conditions
Select an event condition and choose [Enable] from the popup menu to enable the selected event
condition.
5.5.24 Disabling Event Conditions
Select an event condition and choose [Disable] from the popup menu to disable the selected event
condition. When an event condition is disabled, the event condition will remain in the list, but an
event will not occur when the specified conditions have been satisfied.