User`s manual

SuperH Family E10A-USB Emulator Section 5 Debugging
R20UT0870EJ1000 Rev. 10.00 Page 109 of 292
Aug 10, 2012
Items that can be displayed in the sheet are listed below.
[Loading flash memory] Sets Enable for flash memory downloading. At Enable, when
the flash memory is downloaded on the High-performance
Embedded Workshop, the write module is always called.
Disable: Not download to the flash memory
Enable: Download to the flash memory
[Erasing flash memory] Sets Enable for erasing before the flash memory is
programmed. At Enable, the erase module is called before
calling the write module.
Disable: Not erase the flash memory
Enable: Erase the flash memory
[File name] Sets the write/erase module name. The file that has been set is
loaded to the RAM area before loading to the flash memory.
[Bus width of flash memory] Sets the bus width of the flash memory.
[Flash memory erasing time] Sets the TIMEOUT value at flash memory erasing. Increase
the value if erasing requires much time although the default
time is three minutes. The values that can be set are as follows:
D'0 (minimum) and D’65535 (maximum). Only positive
integers can be input.
[Entry point] Sets the calling destination address or access size of the
write/erase module. (It must be RAM address.)
All erasing module address: Inputs the calling destination
address of the erase module.
Writing module address: Inputs the calling destination
address of the write module.
Access size: Selects the access size of the RAM
area that is used for loading the
write/erase module.