User`s manual

SuperH Family E10A-USB Emulator Section 4 Preparations for Debugging
R20UT0870EJ1000 Rev. 10.00 Page 103 of 292
Aug 10, 2012
4.5 Reconnecting the Emulator
When the emulator is disconnected, use the following way for reconnection:
Select [Debug -> Connect] or click the [Connect] toolbar button (
). The emulator is connected.
Note: The emulator must be selected in the [Target] drop-down list box of the [Debug Settings]
dialog box (see figure 4.13, [Debug Settings] Dialog Box ([Target] Page)) that is opened
by selecting [Debug settings] from the [Debug] menu.
4.6 Ending the Emulator
When using the toolchain, the emulator can be exited by using the following two methods:
 Canceling the connection of the emulator being activated
 Exiting the High-performance Embedded Workshop
(1) Canceling the connection of the emulator being activated
Select [Disconnect] from the [Debug] menu or click the [Disconnect] toolbar button (
).
(2) Exiting the High-performance Embedded Workshop
Select [Exit] from the [File] menu.
A message box is displayed. If necessary, click the [Yes] button to save a session. After
saving a session, the High-performance Embedded Workshop exits. If not necessary, click the
[No] button to exit the High-performance Embedded Workshop.
Figure 4.33 [Session has been modified] Message Box