User`s manual

SuperH Family E10A-USB Emulator Section 4 Preparations for Debugging
R20UT0870EJ1000 Rev. 10.00 Page 88 of 292
Aug 10, 2012
4.2.3 Setting the Writing Flash Memory Mode
The following describes the procedures when the emulator is used as a tool for programming of
the internal ROM. The load module to be downloaded to the new workspace is registered and
programmed.
Note: 1. When the [Writing Flash memory] mode is selected, command chains registered on the
[Options] page of the [Debug Settings] dialog box must be removed. The [Reset CPU
after download module] checkbox must also be deselected.
2. The emulator is also usable as a programming tool in mass production when it is
operating in the [Writing Flash Memory] mode.
However, the flash memory of an actual MCU which has been used in connection with
the E10A-USB Emulator for debugging will have been programmed at emulation and
subjected to stress accordingly. Do not use an MCU that has been used for debugging
in a mass-produced product.
(a) Select the new project workspace.