User`s manual

M38000T2-CPE User’s Manual 1. Outline
REJ10J0301-0400 Rev.4.00 March 01, 2006
Page 19 of 78
1.3 Specifications
Table 1.6 lists specifications of the M38000T2-CPE.
Table 1.6 M38000T2-CPE specifications
Applicable MCUs 740 Family MCUs which have emulator MCUs
*1
Usable mode Single-chip mode
Memory expansion mode
Microprocessor mode
Maximum operating frequency
10 MHz (frequency/1 mode, 0-wait)
Minimum operating frequency 32.768 kHz (frequency/2 mode)
When the emulator MCU is
RSS or RFS type.
2.7 to 5.0 V (within the MCU's specified range)
Applicable power supply
When the emulator MCU is
RLSS or RLFS type.
1.8 to 5.0 V (within the MCU's specified range)
Emulation memory 64 KB (can be mapped by 64 bytes)
Clock supply Only the clock on the user system can be used.
Basic debugging functions - Download
- Software break (max. 64 points, break before execution)
- Program execution/stop (allows free-run execution supporting software breaks)
- Memory reference/setting (reference/setting C-variables, run-time execution)
- Register reference/setting
- C-level debugging, etc.
Recording cycle
32768 cycles
(Address, data, MCU status)
Real-time trace function
Trace mode
- Before Break mode
32768 cycles of instruction execution before the user
program stopped is recorded.
- After Go mode
32768 cycles of instruction execution after an event was met
is recorded.
Hardware break function Hardware break point 1 point (Address match, bus match, max. 256 pass counts)
Time measurement point Time between program start and stop
Resolution 100 ns
Execution time measurement
function
Count source Emulator timer
Real-time RAM monitor
function
1,024 bytes
Connection to user system Via an emulator MCU and converter board prepared for each MCU.
Power supply for emulator
DC 5.0 V ±5% (2 A) externally supplied (prepare the power supply separately)
Host machine interface USB (USB 1.1
*2
full-speed, mini-B standard connector)
*1 Applicable MCUs are occasionally updated. For more information on applicable MCUs, please visit the Renesas Tool
Homepage at http://www.renesas.com/en/tools
*2 Available to connect the host machine that supports USB 2.0. With the USB interface, not all hardware (such as host
machine, USB devices, USB hub) combination will work and guaranteed.