Technical information

µClinux-SH7670
15
D008961_11_S01_V01
Setup Guide
When the IP address details have been input, click on OK to close this window and apply the new IP address settings.
Web Front End
To connect to the web front end, enter the board’s IP address (http://192.168.1.100/) into a Web browser. The home page
(shown below) should appear. If it does not then Firewall settings may also need to be changed. Contact an IT
Administrator for help.
Navigation Options:
Mount and Unmount:
When a USB Pen Drive is plugged in to the RSK2+SH7670 board, use this option to mount the file system from it.
The Web Front End will detect whether the system was successfully mounted, and change the option to show
“Unmount USB”. If the system continues to show “Mount USB”, it may be necessary to unplug the USB stick and
re-insert. Allow the board at least 5 seconds to try to load the driver before trying to mount the USB stick.
If the USB stick is pulled out without un-mounting the device, it will leave the system in an unknown state, and it
will not be able to remount. Power cycle the board to recover from an unknown state.
Browse USB Stick:
When the device has been mounted, use the Browse USB stick command to change the working directory of the
image browser.
The Web Front End will search for images in a folder called /imgs on the USB memory stick.
>> Next Image
<< Previous Image:
These options will allow you to cycle through the images available on the current file system
Rotate Image:
This option will allow you to rotate the current image clockwise on the board.