Technical information

µClinux-SH7670
11
D008961_11_S01_V01
Setup Guide
Flashing the images to the board
Once connected, the image can be downloaded to the board through the debug menu
This may take approximately 2 minutes.
Once the binary file “sh-uclinux-bin” is programmed to the RSK2+SH7670 board the programming is complete. Click the
‘Disconnect’ icon on HEW debug toolbar, and power down the power supply and remove the programming cable from the
RSK2+SH7670 board. Re-apply the power to boot the board and run the demo.