Technical information

µClinux-SH7670
9
D008961_11_S01_V01
Setup Guide
Setting the board initialisation script
1. Select the “Debug Settings” menu option from the “Debug” menu.
2. Add the binary file that are available for downloading to the board, to the target download section. In the Download
Module Dialog, the Format should be set to “Binary” and the Access Size should be set to 4.
The sh-uclinux-full binary should be written at address 0x00000000.
3. Finally under the options tab it is necessary to add a batch file operation to run before download of modules. This batch
file is required to set up the board initially for access by the FMtool when flashing.