Technical information

µClinux-SH7670
8
D008961_11_S01_V01
Setup Guide
2. On the “Loading Flash Memory” tab set “Loading flash memory” to enable. This will enable the configuration of the rest
f the dialog control. Then set “Erasing flash memory” to enable. This will enable the erasing details to be configured.
nnects of the board, and you will need to check this page every time
• “fmtool_MultiBank.mot”.
$PROJECT_DIR\$PROJECT_NAME\Flash_Tool\
inally ensure the Entry point addresses are correct. H’FFF80000
o
• These settings are not retained through disco
you reconnect to the RSK2+SH7670 board.
“File name” should point to the chip erase tool
This file is located in the following directory:
F
3. Click “OK” to save the settings.