User`s manual

RX62N Group, RX621 Group 1. Introduction
1.3.10. Using the library with debug information
RPDL library with debug information should be chosen, in order to step in the RPDL source code for debugging.
Unzip the RPDL source zip file (e.g. "RPDL_RX62N_CS.x.xx_source.zip") into a folder (e.g.
"c:\my_project_folder").
Set a breakpoint at the RPDL API to be debugged.
When the program break at the RPDL API, press "F11" key to step in the function.
A pop-up window will appear to request for the location of the corresponding RPDL source file.
Select the folder where you unzip the RPDL source file, and open the source file under respective module folder.
Once the correct source file is selected, user could step in to the file and step through the function.
R20UT0084EE0112 Rev.1.12 Page 1-14
July. 16, 2014