User`s manual

RX62N Group, RX621 Group 4. Library Reference
Description (6/8)
[data7]
Configure the operation for general registers TGRC and TGRD. Valid for n = 0, 3, 4, 6, 9 and 10.
If multiple selections are required, use "|" to separate each selection.
The default settings are shown in bold. Specify PDL_NO_DATA to use the defaults.
•
Input capture / output compare control for register TGRC.
PDL_MTU2_C_OC_DISABLED or
PDL_MTU2_C_OC_LOW or
PDL_MTU2_C_OC_LOW_CM_HIGH or
PDL_MTU2_C_OC_LOW_CM_INV or
PDL_MTU2_C_OC_HIGH_CM_LOW or
PDL_MTU2_C_OC_HIGH or
PDL_MTU2_C_OC_HIGH_CM_INV or
MTIOCnC output disabled.
MTIOCnC output low.
MTIOCnC initial output low; goes high at compare
match.
MTIOCnC initial output low; toggles at compare
match.
MTIOCnC initial output high; goes low at compare
match.
MTIOCnC output high.
MTIOCnC initial output high; toggles at compare
match.
PDL_MTU2_C_IC_RISING_EDGE or
PDL_MTU2_C_IC_FALLING_EDGE or
PDL_MTU2_C_IC_BOTH_EDGES or
Input capture at MTIOCnC rising edge.
Input capture at MTIOCnC falling edge.
Input capture at MTIOCnC both edges.
PDL_MTU2_C_IC_COUNT
Input capture at channel (n+1) up-count or
down-count. Valid only for n = 0 or 6.
•
Input capture / output compare control for register TGRD.
PDL_MTU2_D_OC_DISABLED or
PDL_MTU2_D_OC_LOW or
PDL_MTU2_D_OC_LOW_CM_HIGH or
PDL_MTU2_D_OC_LOW_CM_INV or
PDL_MTU2_D_OC_HIGH_CM_LOW or
PDL_MTU2_D_OC_HIGH or
PDL_MTU2_D_OC_HIGH_CM_INV or
MTIOCnD output disabled.
MTIOCnD output low.
MTIOCnD initial output low; goes high at compare
match.
MTIOCnD initial output low; toggles at compare
match.
MTIOCnD initial output high; goes low at compare
match.
MTIOCnD output high.
MTIOCnD initial output high; toggles at compare
match.
PDL_MTU2_D_IC_RISING_EDGE or
PDL_MTU2_D_IC_FALLING_EDGE or
PDL_MTU2_D_IC_BOTH_EDGES or
Input capture at MTIOCnD rising edge.
Input capture at MTIOCnD falling edge.
Input capture at MTIOCnD both edges.
PDL_MTU2_D_IC_COUNT
Input capture at channel (n+1) up-count or
down-count. Valid only for n = 0 or 6.
R20UT0084EE0112 Rev.1.12 Page 4-97
July. 16, 2014