User Manual
Table Of Contents
- 1. Overview
- 2. External view
- 3. Parts Layout
- 4. Operating Environment
- 5. User Circuits
- 6. Wireless evaluation
- 7. Hardware specifications
- 7.1 North America Band
- 7.1.1 OFDM、Channel Spacing = 1200KHz、Modulation = Option1 / MCS6 / 2400kbps
- 7.1.2 OFDM、Channel Spacing = 800KHz、Modulation = Option2 / MCS6 / 1200kbps
- 7.1.3 OFDM、Channel Spacing = 400KHz、Modulation = Option3 / MCS6 / 600kbps
- 7.1.4 OFDM、Channel Spacing = 200KHz、Modulation = Option4 / MCS6 / 300kbps
- 7.1.5 FSK、Channel Spacing = 200KHz、50kbps / m = 1.0
- 7.1.6 FSK、Channel Spacing = 400KHz、150kbps / m = 0.5
- 7.1 North America Band
- 8. Additional Information
- 9. Certification of Compliance
RTK0EE0013D10001BJ Section 9 Certification of Compliance
R02UZ0004EJ0100 Rev.1.00 Page 19 of 24
Dec.31.22
9. Certification of Compliance
This product complies with the laws and regulations described below.
Radio-Related Laws
North America: FCC ID：2AEMXCWXMRTK1BJ
FCC Regulatory
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that it
deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be
installed and operated keeping the radiator at least 20cm or more away from person's body.
This equipment has been tested and meets the FCC RF exposure guidelines when used with the Renesas
accessories supplied or designated for this product. Use of other accessories may not ensure compliance with
FCC RF exposure guidelines.
This equipment must be used with the approved antenna included in the product.
The certified antenna include:
TERMINAL DIPOLE ANTENNA (Taoglas: TI.92.2113) with peak gain 2.14dBi.
The antenna of this product permanently glued with epoxy to the SMA connector and cannot be removed.