User Manual

RTK0EE0013D10001BJ Section 4 Operating Environment
R02UZ0004EJ0100 Rev.1.00 Page 8 of 24
Dec.31.22
4. Operating Environment
Figure 4-1 shows the operating environment of this product. Install “Virtual COM Port USB Driver” on the host
PC. In addition, install the serial terminal software as it will be used for wireless evaluation.
Figure 4-1: Operating Environment
Virtual COM Port USB Driver
If your PC is connected to the Internet, Windows Update will automatically install the latest driver. Please wait
until you see the following pop-up message: Your device is ready to use. If you have not yet installed the
driver on your PC, Download and install the driver. Virtual COM port drivers can be downloaded from the FTDI
website. FTDI manufactures USB chips embedded in this product.
FTDI website：
http://www.ftdichip.com/Drivers/VCP.htm
Serial Terminal Software
The serial terminal software enables data to be input to and output from a serial console.
The serial terminal settings are as shown in Table 4-1.
Table 4-1: Serial Terminal Settings
Setting item
Setting value
Baud rate
500000 bps
Data
8 bits
Parity
None
Stop bit
1 bit
Flow control
Not used
Newline code
Reception: LF or AUTO
Transmission: CR+LF or LF
Local echo
Enabled
Note:
Windows does not come with serial terminal software. Please use the free terminal software of your choice.