Quick Start Renesas Starter Kit for R8C/2F LCD module LCD module Application interface header Serial port Reset switch DC power in E8A Header User LEDs LIN User switches Application interface Analog adjust E8A debugger module
1. Installation Do not connect the E8A debugger hardware until the software support has been installed. 1. Insert the CD into your computer’s CD-ROM drive. The CD should automatically run the installation program. If the installer does not start, browse to the CD root folder and double click on ‘setup.exe’. 2. The installer will ask you which language is to be used, please choose the appropriate one. 3. On the first screen of the installer proper, click . 4.
2. Choose ‘User Flash Area’ in ‘Firmware Location’ tab. 33. Choose communication baud rate ”500000bps” and press . 34. The Flash Memory write program is downloaded and the output window in HEW will state ‘Connected’. 35. Right click on the download module listed in the left hand pane and select ‘Download’. The code will be downloaded to the microcontroller. This may take several seconds. 36. Click the button. The code will run and you will see the LEDs flash on the board. 37.
7. Support Online technical support and information is available at: www.renesas.com/renesas_starter_kits Technical Contact Details America: techsupport.rta@renesas.com Europe: tools.support.eu@renesas.com Japan: csc@renesas.com Note on Autoupdate: The Autoupdater is configured to automatically add itself to the Startup folder in the Windows Start Menu and use the registry defaults for access to the web. After restarting the machine the Icon will appear in the System Tray next to the clock.
