Datasheet
R01DS0063EJ0120 Rev.1.20 Page 4 of 95
Feb 6, 2013
R32C/116 Group 1. Overview
Note:
1. Contact a Renesas Electronics sales office to use the optional features.
Table 1.3 Performance Overview for the 100-pin Package (1/2)
Unit Function Explanation
CPU Central
processing unit
R32C/100 Series CPU Core
• Basic instructions: 108
• Minimum instruction execution time: 15.625 ns (f(CPU) = 64 MHz)
• Multiplier: 32-bit × 32-bit 64-bit
• Multiply-accumulate unit: 32-bit × 32-bit + 64-bit 64-bit
• IEEE-754 compatible FPU: Single precision
• 32-bit barrel shifter
• Operating mode: Single-chip mode, memory expansion mode,
microprocessor mode (optional
(1)
)
Memory Flash memory: 384 Kbytes to 1 Mbyte
RAM: 40 K/48 K/63 Kbytes
Data flash: 4 Kbytes × 2 blocks
Refer to Table 1.5 for each product’s memory size
Voltage
Detector
Low voltage
detector
Optional
(1)
Low voltage detection interrupt
Clock Clock generator • 4 circuits (main clock, sub clock, PLL, on-chip oscillator)
• Oscillation stop detector: Main clock oscillator stop/restart detection
• Frequency divide circuit: Divide-by-2 to divide-by-24 selectable
• Low power modes: Wait mode, stop mode
External Bus
Expansion
Bus and memory
expansion
• Address space: 4 Gbytes (of which up to 64 Mbytes is user
accessible)
• External bus Interface: Support for wait-state insertion, 4 chip select
outputs
• Bus format: Separate bus/Multiplexed bus selectable, data bus width
selectable (8/16 bits)
Interrupts Interrupt vectors: 261
External interrupt inputs: NMI, INT × 6, key input × 4
Interrupt priority levels: 7
Watchdog Timer 15 bits × 1 (selectable input frequency from prescaler output)
DMA DMAC 4 channels
• Cycle-steal transfer mode
• Request sources: 51
• 2 transfer modes: Single transfer, repeat transfer
DMAC II • Triggered by an interrupt request of any peripheral
• 3 characteristic transfer functions: Immediate data transfer,
calculation result transfer, chain transfer
I/O Ports Programmable
I/O ports
• 2 input-only ports
• 84 CMOS I/O ports (of which 32 are 5 V tolerant)
• A pull-up resistor is selectable for every 4 input ports (except 5 V
tolerant inputs)