Datasheet

R01DS0032EJ0200 Rev.2.00 Page 3 of 88
Feb 07, 2011
M16C/64A Group 1. Overview
Notes:
1. See Table 1.3 “Product List” for the operating temperature.
2. The CEC function indicates circuitry which supports the transmission and reception of CEC signals standardized
by the High-Definition Multimedia Interface (HDMI). HDMI and High-Definition Multimedia Interface are
registered trademarks of HDMI Licensing, LLC.
Table 1.2 Specifications for the 100-Pin Package (2/2)
Item Function Description
Timers
Timer A
16-bit timer × 5
Timer mode, event counter mode, one-shot timer mode, pulse width
modulation (PWM) mode
Event counter two-phase pulse signal processing (two-phase encoder
input) × 3
Programmable output mode × 3
Timer B
16-bit timer × 6
Timer mode, event counter mode, pulse period measurement mode,
pulse width measurement mode
Three-phase motor control
timer functions
• Three-phase inverter control (timer A1, timer A2, timer A4, timer B2)
• On-chip dead time timer
Real-time clock Count: seconds, minutes, hours, days of the week
PWM function 8 bits × 2
Remote control signal receiver
• 2 circuits
• 4 wave pattern matchings (differentiate wave pattern for headers, data
0, data 1, and special data)
• 6-byte receive buffer (1 circuit only)
• Operating frequency of 32 kHz
Serial
Interface
UART0 to UART2, UART5 to
UART7
Clock synchronous/asynchronous × 6 channels
I
2
C-bus, IEBus, special mode 2
SIM (UART2)
SI/O3, SI/O4 Clock synchronization only × 2 channels
Multi-master I
2
C-bus Interface
1 channel
CEC Functions
(2)
CEC transmit/receive, arbitration lost detection, ACK automatic output,
operation frequency of 32 kHz
A/D Converter
10-bit resolution × 26 channels, including sample and hold function
Conversion time: 1.72 µs
D/A Converter 8-bit resolution × 2 circuits
CRC Calculator
CRC-CCITT (X
16
+ X
12
+ X
5
+ 1),
CRC-16 (X
16
+ X
15
+ X
2
+ 1) compliant
Flash Memory
• Program and erase power supply voltage: 2.7 to 5.5 V
• Program and erase cycles: 1,000 times (program ROM 1, program
ROM 2), 10,000 times (data flash)
• Program security: ROM code protect, ID code check
Debug Functions On-chip debug, on-board flash rewrite, address match interrupt × 4
Operation Frequency/Supply Voltage 25 MHz/VCC1 = 2.7 to 5.5 V, VCC2 = 2.7 V to VCC1
Current Consumption Described in Electrical Characteristics
Operating Temperature
-20°C to 85°C, -40°C to 85°C
(1)
Package
100-pin QFP: PRQP0100JD-B (Previous package code: 100P6F-A)
100-pin LQFP: PLQP0100KB-A (Previous package code: 100P6Q-A)