Datasheet

RL78/L12
CHAPTER 31 ELECTRICAL SPECIFICATIONS (G: TA = -40 to +105°C)
R01UH0330EJ0200 Rev.2.00 919
Dec 13, 2013
31.3 DC Characteristics
31.3.1 Pin characteristics
(T
A = −40 to +105°C, 2.4 V ≤ EVDD = VDD ≤ 5.5 V, VSS = EVSS = 0 V) (1/5)
Items Symbol Conditions MIN. TYP. MAX. Unit
Output current,
high
Note 1
I
OH1 Per pin for P10 to P17, P30 to P32, P40 to P43, P50 to P54,
P70 to P74, P120, P125 to P127, P130, P140 to P147
-3.0
Note 2
mA
Total of P10 to P14, P40 to P43, P120,
P130, P140 to P147
(When duty = 70%
Note 3
)
4.0 V ≤ EV
DD ≤ 5.5 V -30.0 mA
2.7 V ≤ EVDD < 4.0 V −8.0 mA
2.4 V ≤ EVDD < 2.7 V −4.0 mA
Total of P15 to P17, P30 to P32,
P50 to P54, P70 to P74, P125 to P127
(When duty = 70%
Note 3
)
4.0 V ≤ EV
DD ≤ 5.5 V -30.0 mA
2.7 V ≤ EVDD < 4.0 V −15.0 mA
2.4 V ≤ EVDD < 2.7 V −8.0 mA
Total of all pins
(When duty = 70%
Note 3
)
-60.0 mA
IOH2 P20, P21 Per pin −0.1 mA
Total of all pins 2.4 V ≤ VDD ≤ 5.5 V −0.2 mA
Notes 1. Value of current at which the device operation is guaranteed even if the current flows from the VDD and
EVDD pins to an output pin.
2. Do not exceed the total current value.
3. Specification under conditions where the duty factor ≤ 70%.
The output current value that has changed to the duty factor > 70% the duty ratio can be calculated with the
following expression (when changing the duty factor from 70% to n%).
• Total output current of pins = (I
OH × 0.7)/(n × 0.01)
<Example> Where n = 80% and I
OH = −30.0 mA
Total output current of pins = (−30.0 × 0.7)/(80 × 0.01) ≅ −26.25 mA
However, the current that is allowed to flow into one pin does not vary depending on the duty factor. A
current higher than the absolute maximum rating must not flow into one pin.
Caution P10, P12, P15, and P17 do not output high level in N-ch open-drain mode.
Remark Unless specified otherwise, the characteristics of alternate-function pins are the same as those of the port
pins.