Datasheet

RL78/L12 CHAPTER 12 SERIAL ARRAY UNIT
R01UH0330EJ0200 Rev.2.00 507
Dec 13, 2013
12.7 LIN Communication Operation
12.7.1 LIN transmission
UART0 transmission supports LIN communication.
For LIN transmission, channel 0 is used.
UART UART0
Support of LIN communication Supported
Target channel Channel 0
Pins used TxD0
Interrupt INTST0
Transfer end interrupt (in single-transfer mode) or buffer empty interrupt (in continuous transfer
mode) can be selected.
Error detection flag None
Transfer data length 8 bits
Transfer rate Max. fMCK/6 [bps] (SDR00 [15:9] = 2 or more), Min. fCLK/(2 × 2
15
× 128) [bps]
Note
Data phase Non-reverse output (default: high level)
Reverse output (default: low level)
Parity bit No parity bit
Stop bit Appending 1 bit
Data direction LSB first
Note Use this operation within a range that satisfies the conditions above and the peripheral functions characteristics in
the electrical specifications (see CHAPTER 30 ELECTRICAL SPECIFICATIONS (A, G: T
A = -40 to +85°C) and
CHAPTER 31 ELECTRICAL SPECIFICATIONS (G: TA = -40 to +105°C)). In addition, LIN communication is
usually 2.4/9.6/19.2 kbps is often used.
Remark f
MCK: Operation clock frequency of target channel
f
CLK: System clock frequency