Datasheet

RL78/L12 CHAPTER 26 FLASH MEMORY
R01UH0330EJ0200 Rev.2.00 819
Dec 13, 2013
26.5 Processing Time for Each Command When PG-FP5 Is in Use (Reference Value)
The following shows the processing time for each command (reference value) when PG-FP5 is used as a dedicated
flash memory programmer.
Table 26-10. Processing Time for Each Command When PG-FP5 Is in Use (Reference Value)
PG-FP5 Command Code Flash
8 Kbytes 16 Kbytes 32 Kbytes
Erasing 1 s 1.5 s 1.5 s
Writing 1.5 s 1.5 s 2 s
Verification 1.5 s 1.5 s 1.5 s
Writing after erasing 1.5 s 2 s 2.5 s
Remark The command processing times (reference values) shown in the table are typical values under the
following conditions.
Port: TOOL0 (single-line UART)
Speed: 1,000,000 bps
Mode: Full speed mode (flash operation mode: HS (high speed main) mode)
<R>