Datasheet

RL78/L12 APPENDIX A REVISION HISTORY
R01UH0330EJ0200 Rev.2.00 986
Dec 13, 2013
(8/10)
Edition
Description Chapter
Rev.1.00
Modification of Figure 22-1. Block Diagram of Voltage Detector
CHAPTER 22
VOLTAGE
DETECTOR
Modification of notes 1, 3 in Figure 22-2. Format of Voltage Detection Register (LVIM)
Addition of Table 22-1. LVD Operation Mode and Detection Voltage Settings for User Option
Byte (000C1H)
Modification of 22.4.1 When used as reset mode
Modification of 22.4.2 When used as interrupt mode
Modification of description in 22.4.3 When used as interrupt and reset mode
Modification of figure 22-6 (1/2)
Modification of figure 22-6 (2/2)
Modification of remark in 23.1 Overview of Safety Functions
CHAPTER 23
SAFETY
FUNCTIONS
Addition of description and caution 2 to 23.3.1 Flash memory CRC operation function (high-
speed CRC)
Modification of Figure 23-3. Flowchart of Flash Memory CRC Operation Function (High-speed
CRC)
Addition of description and caution to 23.3.2 CRC operation function (general-purpose CRC)
Modification of Figure 23-6. CRC Operation Function (General-Purpose CRC)
Modification of caution in Figure 23-7. Format of RAM Parity Error Control Register (RPECTL)
Modification of Figure 23-10. Invalid access detection area
Addition of description to 23.3.8 A/D test function
Addition of Figure (move from 2.2 Description to Pin Function (preceding editions)) CHAPTER 24
REGULATOR
Modification of description in 25.1 Functions of Option Bytes
CHAPTER 25
OPTION BYTE
Modification of description in Figure 25-1. Format of User Option Byte (000C0H)
Modification of Figure 25-2. Format of User Option Byte (000C1H)
Deletion of description in 26.1.1 Programming Environment
CHAPTER 26
FLASH MEMORY
Addition of description to 26.2 Writing to Flash Memory by Using External Device (that
Incorporates UART)
Addition of remark to 26.3 Connection of Pins on Board
Addition of description, caution and remark to 26.4.1 Data flash overview
Modification of Figure 26-8. Setting of Flash Memory Programming Mode
Modification of error in Table 26-4. Relationship Between TOOL0 Pin and Operation Mode
After Reset Release
Modification of Table 26-5. Programming Modes and Voltages at Which Data Can Be Written,
Erased, or Verified
Modification of description in Table 26-10. Example of Signature Data
Addition of description and caution to 26.6 Security Settings
Modification of Table 26-11. Relationship Between Enabling Security Function and Command
and Table 26-12. Setting Security in Each Programming Mode
Modification of cautions 2 to 4 to 26.7 Flash Memory Programming by Self-Programming
Modification of Table 26-13. Programming Modes and Voltages at Which Data Can Be Written,
Erased, or Verified
Modification of Table 26-14. Relationship between Flash Shield Window Function
Setting/Change Methods and Commands