Datasheet

RL78/L12 CHAPTER 30 ELECTRICAL SPECIFICATIONS (A, G: T
A = -40 to +85°C)
R01UH0330EJ0200 Rev.2.00 860
Dec 13, 2013
(TA = −40 to +85°C, 1.6 V ≤ EVDD = VDD ≤ 5.5 V, VSS = EVSS = 0 V) (2/5)
Items Symbol Conditions MIN. TYP. MAX. Unit
Output current,
low
Note 1
I
OL1 Per pin for P10 to P17, P30 to P32, P40 to P43,
P50 to P54, P70 to P74, P120, P125 to P127, P130,
P140 to P147
20.0
Note 2
mA
Per pin for P60, P61 15.0
Note 2
mA
Total of P10 to P14, P40 to P43,
P120, P130, P140 to P147
(When duty = 70%
Note 3
)
4.0 V ≤ EV
DD ≤ 5.5 V 70.0 mA
2.7 V ≤ EVDD < 4.0 V 15.0 mA
1.8 V ≤ EVDD < 2.7 V 9.0 mA
1.6 V ≤ EVDD < 1.8 V 4.5 mA
Total of P15 to P17, P30 to P32,
P50 to P54, P60, P61, P70 to P74,
P125 to P127
(When duty = 70%
Note 3
)
4.0 V ≤ EV
DD ≤ 5.5 V 80.0 mA
2.7 V ≤ EVDD < 4.0 V 35.0 mA
1.8 V ≤ EVDD < 2.7 V 20.0 mA
1.6 V ≤ EVDD < 1.8 V 10.0 mA
Total of all pins
(When duty = 70%
Note 3
)
150.0 mA
IOL2 P20, P21 Per pin 0.4 mA
Total of all pins 1.6 V ≤ VDD ≤ 5.5 V 0.8 mA
Notes 1. Value of current at which the device operation is guaranteed even if the current flows from the V
DD and
EVDD pins to an output pin.
2. Do not exceed the total current value.
3. Specification under conditions where the duty factor ≤ 70%.
The output current value that has changed to the duty factor > 70% the duty ratio can be calculated with the
following expression (when changing the duty factor from 70% to n%).
• Total output current of pins = (I
OH × 0.7)/(n × 0.01)
<Example> Where n = 80% and IOL = 70.0 mA
Total output current of pins = (70.0 × 0.7)/(80 × 0.01) ≅ 61.25 mA
However, the current that is allowed to flow into one pin does not vary depending on the duty factor. A
current higher than the absolute maximum rating must not flow into one pin.
Remark Unless specified otherwise, the characteristics of alternate-function pins are the same as those of the port
pins.
<R>
<R>