Datasheet

RL78/L12 CHAPTER 26 FLASH MEMORY
R01UH0330EJ0200 Rev.2.00 808
Dec 13, 2013
Table 26-1. Wiring Between RL78/L12 and Dedicated Flash Memory Programmer
Pin Configuration of Dedicated Flash Memory
Programmer
Pin Name Pin No.
32-pin 44-pin 48-pin 52-pin 64-pin
Signal Name I/O Pin Function WQFN (5x5)
LQFP
(10x10)
LQFP
(7x7)
LQFP
(10x10)
LQFP (12x12),
LQFP (10x10),
WQFN (8x8)
PG-FP5,
FL-PR5
E1 on-chip
debugging
emulator
− TOOL0 I/O
Transmit/receiv
e signal
TOOL0/
P40
1 2 3 4 5
SI/RxD − I/O
Transmit/receiv
e signal
SCK − Output − − − − − − −
CLK − Output − − − − − − −
− RESET Output Reset signal RESET 2 3 4 5 6
/RESET − Output
FLMD0 − Output Mode signal − − − − − −
VDD I/O
V
DD voltage
generation/
power monitoring
V
DD 8 11 12 13 15
GND − Ground VSS 7 10 11 12 13
EVSS − − − − 14
REGC
Note
6 9 10 11 12
EMVDD −
Driving power
for TOOL pin
VDD 8 11 12 13 −
EVDD − − − − 16
Note Connect REGC pin to ground via a capacitor (0.47 to 1 μ F).
Remark Pins that are not indicated in the above table can be left open when using the flash memory programmer for
flash programming.
<R>