Datasheet

RL78/L12 CHAPTER 2 PIN FUNCTIONS
R01UH0330EJ0200 Rev.2.00 23
Dec 13, 2013
(2/2)
Function
Name
Pin Type I/O After Reset Alternate Function Function
P60 12-1-4 I/O
Digital input
invalid
SCLA0/SEG21
Port 6.
2-bit I/O port.
Input/output can be specified in 1-bit units.
P61 SDAA0/SEG20
P120 7-10-1 I/O Analog input port ANI17/SEG25
Port 12.
4-bit I/O port and 4-bit input port.
For P120 and P125 to P127, input/output can be
specified in 1-bit units.
For P120 and P125 to P127, use of an on-chip
pull-up resistor can be specified by a software
setting at input port.
P120 can be set to analog input
Note
.
P121 2-2-1 Input Input port X1
P122 X2/EXCLK
P123 XT1
P124 XT2/EXCLKS
P125 8-5-3 I/O
Digital input
invalid
VL3
P126 8-5-2 CAPL
P127 CAPH
P137 2-1-2 Input Input port INTP0
Port 13.
1-bit input port.
P140 7-5-1 I/O
Digital input
invalid
TO00/PCLBUZ0/
KR3/SEG27
Port 14.
4-bit I/O port.
Input/output can be specified in 1-bit units.
Use of an on-chip pull-up resistor can be specified
by a software setting at input port.
P142 and P143 can be set to analog input
Note
.
P141
TI00/PCLBUZ1/
SEG26
P142 7-10-1 Analog input port ANI20/SEG33
P143 ANI21/SEG34
Note When the each pin is used as input, specify them as either digital or analog in Port mode control register X
(PMCX) (This register can be specified in 1-bit unit).
<R>