Datasheet

RL78/G12 2. ELECTRICAL SPECIFICATIONS (A, D: T
A = −40 to +85°C)
R01DS0193EJ0200 Rev.2.00
Sep 06, 2013
Page 19 of 106
2.3 DC Characteristics
2.3.1 Pin characteristics
(T
A = −40 to +85°C, 1.8 V ≤ VDD ≤ 5.5 V, VSS = 0 V) (1/4)
Parameter Symbol Conditions MIN. TYP. MAX. Unit
Output current, high
Note 1
IOH1
20-, 24-pin products:
Per pin for P00 to P03
Note 4
,
P10 to P14, P40 to P42
30-pin products:
Per pin for P00, P01, P10 to P17, P30,
P31, P40, P50, P51, P120, P147
−10.0
Note 2
mA
20-, 24-pin products:
Total of P40 to P42
30-pin products:
Total of P00, P01, P40, P120
(When duty ≤ 70%
Note 3
)
4.0 V ≤ V
DD ≤ 5.5 V −30.0 mA
2.7 V ≤ VDD < 4.0 V −6.0 mA
1.8 V ≤ VDD < 2.7 V −4.5 mA
20-, 24-pin products:
Total of P00 to P03
Note 4
, P10 to P14
30-pin products:
Total of P10 to P17, P30, P31,
P50, P51, P147
(When duty ≤ 70%
Note 3
)
4.0 V ≤ V
DD ≤ 5.5 V −80.0 mA
2.7 V ≤ VDD < 4.0 V −18.0 mA
1.8 V ≤ VDD < 2.7 V −10.0 mA
Total of all pins (When duty ≤ 70%
Note 3
) −100 mA
IOH2 Per pin for P20 to P23 −0.1 mA
Total of all pins −0.4 mA
Notes 1. value of current at which the device operation is guaranteed even if the current flows from the VDD pin to an
output pin.
2. However, do not exceed the total current value.
3. The output current value under conditions where the duty factor ≤ 70%.
If duty factor > 70%: The output current value can be calculated with the following expression (where n
represents the duty factor as a percentage).
• Total output current of pins = (I
OH × 0.7)/(n × 0.01)
<Example> Where n = 80% and I
OH = −10.0 mA
Total output current of pins = (−10.0 × 0.7)/(80 × 0.01) ≅ −8.7 mA
However, the current that is allowed to flow into one pin does not vary depending on the duty factor. A
current higher than the absolute maximum rating must not flow into one pin.
4. 24-pin products only.
Caution P10 to P12 and P41 for 20-pin products, P01, P10 to P12, and P41 for 24-pin products, and P00, P10
to P15, P17, and P50 for 30-pin products do not output high level in N-ch open-drain mode.
Remark Unless specified otherwise, the characteristics of alternate-function pins are the same as those of the port
pins.
<R>