Datasheet

RL78/G12 2. ELECTRICAL SPECIFICATIONS (A, D: T
A = −40 to +85°C)
R01DS0193EJ0200 Rev.2.00
Sep 06, 2013
Page 18 of 106
2.2 Oscillator Characteristics
2.2.1 X1 oscillator characteristics
(T
A = −40 to +85°C, 1.8 V ≤ VDD ≤ VDD ≤ 5.5 V, VSS = 0 V)
Parameter Resonator Conditions MIN. TYP. MAX. Unit
X1 clock oscillation
frequency (f
X)
Note
Ceramic resonator /
crystal oscillator
2.7 V ≤ V
DD ≤ 5.5 V 1.0 20.0 MHz
1.8 V ≤ VDD < 2.7 V 1.0 8.0
Note Indicates only permissible oscillator frequency ranges. Refer to AC Characteristics for instruction execution
time. Request evaluation by the manufacturer of the oscillator circuit mounted on a board to check the oscillator
characteristics.
Caution Since the CPU is started by the high-speed on-chip oscillator clock after a reset release, check the
X1 clock oscillation stabilization time using the oscillation stabilization time counter status register
(OSTC) by the user. Determine the oscillation stabilization time of the OSTC register and the
oscillation stabilization time select register (OSTS) after sufficiently evaluating the oscillation
stabilization time with the resonator to be used.
Remark When using the X1 oscillator, refer to 5.4 System Clock Oscillator in the RL78/G12 User’s Manual
Hardware.
2.2.2 On-chip oscillator characteristics
(T
A = −40 to +85°C, 1.8 V ≤ VDD ≤ 5.5 V, VSS = 0 V)
Oscillators Parameters Conditions MIN. TYP. MAX. Unit
High-speed on-chip oscillator
clock frequency
Notes 1, 2
f
IH 1 24 MHz
High-speed on-chip oscillator
clock frequency accuracy
R5F102 products TA = −20 to +85°C-1.0
+1.0
%
TA = −40 to −20°C-1.5
+1.5
%
R5F103 products -5.0
+5.0
%
Low-speed on-chip oscillator
clock frequency
f
IL 15 kHz
Low-speed on-chip oscillator
clock frequency accuracy
-15 +15 %
Notes 1. High-speed on-chip oscillator frequency is selected by bits 0 to 3 of option byte (000C2H) and bits 0 to 2 of
HOCODIV register.
2. This only indicates the oscillator characteristics. Refer to AC Characteristics for instruction execution time.
<R>
<R>
<R>
<R>