Datasheet

Section 10 I/O Ports
Page 530 of 1408 R01UH0309EJ0500 Rev. 5.00
Sep 24, 2012
H8S/2456, H8S/2456R, H8S/2454 Group
SSU settings (1) (2) (1) (3) (1) (2) (1) (3)
SSUMS 0 1
MSS 0 1 0 1
SCKS 0 1 0 1 0 1 0 1
Pin state ⎯ SSCK
input
⎯ SSCK
output
⎯ SSCK
input
⎯ SSCK
output
[Legend]
⎯: Not used as the SSU pin (can be used as an I/O port).
Note: See tables 20.4 to 20.6.
• P15/PO13/TIOCB1/TCLKC/SSI0-A
The pin function is switched as shown below according to the combination of TPU channel 1
settings (by bits MD3 to MD0 in TMDR_1, bits IOB3 to IOB0 in TIOR_1, and bits CCLR1
and CCLR0 in TCR_1), bits TPSC2 to TPSC0 in TCR_0, TCR_2, TCR_4, and TCR_5, bit
NDER13 in NDERH of PPG, bits MSS and BIDE in SSCRH, bit SSUMS in SSCRL, and bits
TE and RE in SSER of SSU, bits SSI0S1 and SSI0S0 in PFCR5, and bit P15DDR.
SSU settings (1) in table below (2) in table
below
(3) in table
below
TPU channel 1
settings
(1) in table
below
(2) in table below ⎯
P15DDR ⎯ 0 1 1 0*
5
⎯
NDER13 ⎯ ⎯ 0 1 ⎯
P15 input P15 output PO13 outputTIOCB1 output
TIOCB1 input
*
1
Pin function
TCLKC input*
2
SSI0-A
input*
3
*
6
SSI0-A
output*
4
*
6
Notes: 1. TIOCB1 input when MD3 to MD0 = B'0000 or B'01xx and IOB3 to IOB0 = B'10xx.
2. TCLKC input when the setting for either TCR_0 or TCR_2 is TPSC2 to TPSC0 = B'111,
or when the setting for either TCR_4 or TCR_5 is TPSC2 to TPSC0 = B'101. TCLKC
input when phase counting mode is set for channels 2 and 4.
3. When using as SSI0-A input, set SSI0S1 and SSI0S0 in PFCR5 to B'00 before other
register setting.
4. When using as SSI0-A output, set SSI0S1 and SSI0S0 in PFCR5 to B'00 before other
register setting.
5. P15DDR = 0 when the SSU pin is used as input.
6. Do not set up for SSU unless SSI0S1 and SSI0S0 = B'00 in PFCR5.
Use as I/O port or TPU pin.