Datasheet

Section 13 8-Bit Timers (TMR)
R01UH0310EJ0500 Rev. 5.00 Page 845 of 1384
Sep 25, 2012
H8S/2426, H8S/2426R, H8S/2424 Group
13.7 Interrupt Sources
13.7.1 Interrupt Sources and DTC Activation
There are three 8-bit timer interrupt sources: CMIA, CMIB, and OVI. Their relative priorities are
shown in table 13.4. Each interrupt source is set as enabled or disabled by the corresponding
interrupt enable bit in TCR or TCSR, and independent interrupt requests are sent for each to the
interrupt controller. It is also possible to activate the DTC by means of CMIA and CMIB
interrupts.
Table 13.4 8-Bit Timer Interrupt Sources
Name Interrupt Source Interrupt Flag DTC Activation Priority
CMIA0 TCORA_0 compare match CMFA Possible High
CMIB0 TCORB_0 compare match CMFB Possible
OVI0 TCNT_0 overflow OVF Not possible Low
CMIA1 TCORA_1 compare match CMFA Possible High
CMIB1 TCORB_1 compare match CMFB Possible
OVI1 TCNT_1 overflow OVF Not possible Low
13.7.2 A/D Converter Activation
The A/D converter can be activated only by TMR_0 compare match A. If the ADTE bit in TCSR0
is set to 1 when the CMFA flag is set to 1 by the occurrence of TMR_0 compare match A, a
request to start A/D conversion is sent to the A/D converter. If the 8-bit timer conversion start
trigger has been selected on the A/D converter side at this time, A/D conversion is started.