Datasheet

Section 7 DMA Controller (DMAC)
Page 390 of 1384 R01UH0310EJ0500 Rev. 5.00
Sep 25, 2012
H8S/2426, H8S/2426R, H8S/2424 Group
(4) DREQ Pin Low Level Activation Timing
Set the DTA bit in DMABCRH to 1 for the channel for which the DREQ pin is selected.
Figure 7.31 shows an example of single address mode transfer activated by the DREQ pin low
level.
DREQ
Bus release DMA single
Address bus
φ
DMA control
Channel
[2]
DACK
Transfer source/
destination
Idle Idle Idle
[1] [3] [5][4] [6] [7]
Acceptance resumesAcceptance resumes
Bus release DMA single
Bus
release
Transfer source/
destination
Request Request
Request clear
period
Request clear
period
Single
Single
Minimum of
2 cycles
Minimum of
2 cycles
[1] Acceptance after transfer enabling; the DREQ pin low level is sampled on the rising edge of φ,
and the request is held.
[2] [5] The request is cleared at the next bus break, and activation is started in the DMAC.
[3] [6] The DMAC cycle is started.
[4] [7] Acceptance is resumed after the single cycle is completed.
(As in [1], the DREQ pin low level is sampled on the rising edge of φ, and the request is held.)
Note: In write data buffer mode, bus breaks from [2] to [7] may be hidden, and not visible.
Figure 7.31 Example of DREQ Pin Low Level Activated Single Address Mode Transfer