Datasheet
Section 6 Bus Controller (BSC) 
R01UH0310EJ0500 Rev. 5.00    Page 309 of 1384 
Sep 25, 2012     
H8S/2426, H8S/2426R, H8S/2424 Group 
6.13  Bus Arbitration 
This LSI has a bus arbiter that arbitrates bus mastership operations (bus arbitration). 
There are four bus masters⎯the CPU, DTC, DMAC, and EXDMAC*⎯that perform read/write 
operations when they have possession of the bus. Each bus master requests the bus by means of a 
bus request signal. The bus arbiter determines priorities at the prescribed timing, and permits use 
of the bus by means of a bus request acknowledge signal. The selected bus master then takes 
possession of the bus and begins its operation. 
Note:  *  The EXDMAC is not supported by the H8S/2424 Group. 
6.13.1  Operation 
The bus arbiter detects the bus masters' bus request signals, and if the bus is requested, sends a bus 
request acknowledge signal to the bus master. If there are bus requests from more than one bus 
master, the bus request acknowledge signal is sent to the one with the highest priority. When a bus 
master receives the bus request acknowledge signal, it takes possession of the bus until that signal 
is canceled. 
The order of priority of the bus mastership is as follows: 
 (High) EXDMAC*
2
 > DMAC > DTC > CPU (Low) 
An internal bus access by internal bus masters except the EXDMAC*
2
 and external bus release, a 
refresh when the CBRM bit is 0, and an external bus access by the EXDMAC*
2
 can be executed in 
parallel. 
If an external bus release request, a refresh request*
1
, and an external access by an internal bus 
master occur simultaneously, the order of priority is as follows: 
 (High) Refresh*
1
 > EXDMAC*
2
 > External bus release (Low) 
  (High) External bus release > External access by internal bus master except EXDMAC*
2
 (Low) 
As a refresh*
1
 when the CBRM bit in REFCR is cleared to 0 and an external access other than to 
DRAM space by an internal bus master can be executed simultaneously, there is no relative order 
of priority for these two operations. 
Notes: 1.  Not supported by the 5-V version. 
2.  The EXDMAC is not supported by the H8S/2424 Group. 










