Datasheet
Section 21 Flash Memory
Page 1084 of 1384 R01UH0310EJ0500 Rev. 5.00
Sep 25, 2012
H8S/2426, H8S/2426R, H8S/2424 Group
21.3 On-Board Programming Mode
When the mode pins (MD0, MD1, and MD2) are set to on-board programming mode and the reset
start is executed, a transition is made to on-board programming mode in which the on-chip flash
memory can be programmed/erased. On-board programming mode has two operating modes: SCI
boot mode and user programming mode.
Table 21.3 shows the pin setting for each operating mode.
Table 21.3 On-Board Programming Mode Setting
Mode Setting EMLE MD2 MD1 MD0
SCI boot mode 0 0 1 1
User programming mode Single-chip mode, on-chip ROM enabled
expanded mode