Datasheet

Section 10 I/O Ports
R01UH0310EJ0500 Rev. 5.00 Page 651 of 1384
Sep 25, 2012
H8S/2426, H8S/2426R, H8S/2424 Group
10.12.7 Port D Input Pull-Up MOS States
Port D has a built-in input pull-up MOS function that can be controlled by software. This input
pull-up MOS function can be used in modes 3 and 7. The input pull-up MOS can be specified as
on or off on a bit-by-bit basis.
In modes 3 and 7, when a PDDDR bit is cleared to 0, setting the corresponding PDPCR bit to 1
turns on the input pull-up MOS for that pin.
Table 10.6 summarizes the input pull-up MOS states.
Table 10.6 Input Pull-Up MOS States for Port D
Mode Reset
Hardware
Standby Mode
Software
Standby Mode
In Other
Operations
1, 2, or 4 Off Off Off Off
3, 7 On/Off On/Off
[Legend]
Off: Input pull-up MOS is always off.
On/Off: Input pull-up MOS is on when PDDDR = 0 and PDPCR = 1; otherwise off.