Datasheet

Section 16 I2C Bus Interface 2 (IIC2)
R01UH0310EJ0500 Rev. 5.00 Page 979 of 1384
Sep 25, 2012
H8S/2426, H8S/2426R, H8S/2424 Group
16.4.5 Slave Receive Operation
In slave receive mode, the master device outputs the transmit clock and transmit data, and the
slave device returns an acknowledge signal. The reception procedure and operations in slave
receive mode are described below.
1. Set the ICE bit in ICCRA to 1. Set the MLS and WAIT bits in ICMR and the CKS3 to CKS0
bits in ICCRA to 1. (Initial setting) Set the MST and TRS bits in ICCRA to select slave receive
mode, and wait until the slave address matches.
2. When the slave address matches in the first frame following detection of the start condition,
the slave device outputs the level specified by ACKBT in ICIER to SDA, at the rise of the 9th
clock pulse. At the same time, RDRF in ICSR is set to read ICDRR (dummy read) and RDRF
is cleared. (Since the read data show the slave address and R/W, it is not used.)
3. Clear RDRF after reading ICDRR every time RDRF is set. If 8th receive clock pulse falls
while RDRF is 1, SCL is fixed low until ICDRR is read. The change of the acknowledge
before reading ICDRR, to be returned to the master device, is reflected to the next transmit
frame.
4. The last byte data is read by reading ICDRR.