Datasheet

Section 20 Boundary Scan (JTAG)
Rev. 3.00 Sep. 28, 2009 Page 622 of 710
REJ09B0384-0300
8. If a pin with a pull-up function is sampled while its pull-up function is enabled, 1 can be
detected at the corresponding input scan register. In this case, the corresponding enable scan
register should be cleared to 0.
9. If a pin with an open-drain function is sampled while its open-drain function is enabled and its
corresponding output scan register is 1, 0 can be detected at the corresponding enable scan
register.
ETDI
SDIR SDIR
ETDO
Shift register
Shift register
Bit 31 Bit 31
Bit 0 Bit 0
SDIR serial data input/output
SDIR is captured into the shift register in Capture-IR, and bits 0 to 31 of SDIR are output in that order
from the ETDO pin in Shift-IR.
Data input from the ETDI pin is written to SDIR in Update-IR.
.
.
.
.
.
.
.
.
.
.
.
Capture-IR
ETDI
ETDO
Bit 31
Bit 31
Bit 28 Bit 28
.
.
.
Update-IR
Figure 20.4 Serial Data Input/Output (1)