Datasheet

Section 20 Boundary Scan (JTAG)
Rev. 3.00 Sep. 28, 2009 Page 618 of 710
REJ09B0384-0300
20.4.2 JTAG Reset
The JTAG can be reset in two ways.
• The JTAG is reset when the ETRST pin is held at 0.
• When ETRST = 1, the JTAG can be reset by inputting at least five ETCK clock cycles while
ETMS = 1.
20.5 Boundary Scan
The JTAG pins can be placed in the boundary scan mode stipulated by the IEEE1149.1 standard
by setting a command in SDIR.
20.5.1 Supported Instructions
This LSI supports the three essential instructions defined in the IEEE1149.1 standard (BYPASS,
SAMPLE/PRELOAD, and EXTEST) and optional instructions (CLAMP, HIGHZ, and IDCODE).
(1) BYPASS (Instruction code: B'1111)
The BYPASS instruction is an instruction that operates the bypass register. This instruction
shortens the shift path to speed up serial data transfer involving other chips on the printed circuit
board. While this instruction is being executed, the test circuit has no effect on the system
circuits.
(2) SAMPLE/PRELOAD (Instruction code: B'0100)
The SAMPLE/PRELOAD instruction inputs values from this LSI internal circuitry to the
boundary scan register, outputs values from the scan path, and loads data onto the scan path.
When this instruction is being executed, this LSI's input pin signals are transmitted directly to the
internal circuitry, and internal circuit values are directly output externally from the output pins.
This LSI system circuits are not affected by execution of this instruction.
In a SAMPLE operation, a snapshot of a value to be transferred from an input pin to the internal
circuitry, or a value to be transferred from the internal circuitry to an output pin, is latched into the
boundary scan register and read from the scan path. Snapshot latching does not affect normal
operation of this LSI.