Datasheet

Section 19 Flash Memory
Rev. 3.00 Sep. 28, 2009 Page 540 of 710
REJ09B0384-0300
(1) SCI Interface Setting by Host
When boot mode is initiated, this LSI measures the low period of asynchronous SCI-communica-
tion data (H'00), which is transmitted consecutively by the host. The SCI transmit/receive format
is set to 8-bit data, 1 stop bit, and no parity. This LSI calculates the bit rate of transmission by the
host by means of the measured low period and transmits the bit adjustment end sign (1 byte of
H'00) to the host. The host must confirm that this bit adjustment end sign (H'00) has been received
normally and transmits 1 byte of H'55 to this LSI. When reception is not executed normally, boot
mode is initiated again (reset) and the operation described above must be executed. The bit rate
between the host and this LSI is not matched by the bit rate of transmission by the host and system
clock frequency of this LSI. To operate the SCI normally, the transfer bit rate of the host must be
set to 9,600 bps or 19,200 bps.
The system clock frequency, which can automatically adjust the transfer bit rate of the host and
the bit rate of this LSI, is shown in table 19.6. Boot mode must be initiated in the range of this
system clock.
D0 D1 D2 D3 D4 D5 D6 D7
Start
bit
Stop bit
Measure low period (9 bits) (data is H'00) High period of
at least 1 bit
Figure 19.7 Automatic-Bit-Rate Adjustment Operation of SCI
Table 19.6 System Clock Frequency for Automatic-Bit-Rate Adjustment by This LSI
Bit Rate of Host System Clock Frequency
9,600 bps 20 to 25 MHz
19,200 bps