Datasheet

Section 16 LPC Interface (LPC)
Rev. 3.00 Sep. 28, 2009 Page 450 of 710
REJ09B0384-0300
16.3.20 SMIC Interrupt Register 1 (SMICIR1)
SMICIR1 is one of the registers used to implement SMIC mode. This register includes the bits that
enables/disables an interrupt to the slave. The IBFI3 interrupt is enabled by setting the IBFIE3 bit
in HICR2 to 1.
R/W
Bit Bit Name Initial Value Slave Host Description
7 to 5 ⎯ All 0 R/W ⎯
Reserved
The initial value should not be changed.
4 HDTWIE 0 R/W ⎯ Transfer Data Transmission End Interrupt Enable
Enables or disables HDTWI interrupt that is IBFI3
interrupt source to the slave.
0: Disables transfer data transmission end interrupt.
1: Enables transfer data transmission end interrupt.
3 HDTRIE 0 R/W ⎯ Transfer Data Receive End Interrupt Enable
Enables or disables HDTRI interrupt that is IBFI3
interrupt source to the slave.
0: Disables transfer data receive end interrupt.
1: Enables transfer data receive end interrupt.
2 STARIE 0 R/W ⎯ Status Code Receive End Interrupt Enable
Enables or disables STARI interrupt that is IBFI3
interrupt source to the slave.
0: Disables status code receive end interrupt.
1: Enables status code receive end interrupt.
1 CTLWIE 0 R/W ⎯ Control Code Transmission End Interrupt Enable
Enables or disables CTLWI interrupt that is IBFI3
interrupt source to the slave.
0: Disables control code transmission end interrupt.
1: Enables control code transmission end interrupt.
0 BUSYIE 0 R/W ⎯ Transfer Start Interrupt Enable
Enables or disables BUSYI interrupt that is IBFI3
interrupt source to the slave.
0: Disables transfer start interrupt.
1: Enables transfer start interrupt.