Datasheet

Section 16 LPC Interface (LPC)
Rev. 3.00 Sep. 28, 2009 Page 424 of 710
REJ09B0384-0300
16.3.6 Input Data Registers 1 to 3 (IDR1 to IDR3)
The IDR registers are 8-bit read-only registers to the slave processor (this LSI), and 8-bit write-
only registers to the host processor. The registers selected from the host according to the I/O
address are described in the following sections: for information on IDR1 and IDR2 selection, see
section 16.3.4, LPC Channel 1, 2 Address Register H, L (LADR12H, LADR12L), and for
information on IDR3 selection, see section 16.3.5, LPC Channel 3 Address Register H, L
(LADR3H, LADR3L). Data transferred in an LPC I/O write cycle is written to the selected
register. The state of bit 2 of the I/O address is latched into the C/D bit in STR, to indicate whether
the written information is a command or data.
The initial values of the IDR registers are undefined.
16.3.7 Output Data Registers 0 to 3 (ODR1 to ODR3)
The ODR registers are 8-bit readable/writable registers to the slave processor (this LSI), and 8-bit
read-only registers to the host processor. The registers selected from the host according to the I/O
address are described in the following sections: for information on ODR1 and ODR2 selection, see
section 16.3.4, LPC Channel 1, 2 Address Register H, L (LADR12H, LADR12L), and for
information on ODR3 selection, see section 16.3.5, LPC Channel 3 Address Register H, L
(LADR3H, LADR3L). In an LPC I/O read cycle, the data in the selected register is transferred to
the host.
The initial values of the ODR registers are undefined.