Datasheet

Section 5 Interrupt Controller
Rev. 3.00 Sep. 28, 2009 Page 69 of 710
REJ09B0384-0300
5.3.3 Break Address Registers A to C (BARA to BARC)
The BAR registers specify an address that is to be a break address. An address in which the first
byte of an instruction exists should be set as a break address.
• BARA
Bit Bit Name
Initial
Value
R/W Description
7 to 0 A23 to A16 All 0 R/W Addresses 23 to 16
The A23 to A16 bits are compared with A23 to A16 in the
internal address bus.
• BARB
Bit Bit Name
Initial
Value
R/W Description
7 to 0 A15 to A8 All 0 R/W Addresses 15 to 8
The A15 to A8 bits are compared with A15 to A8 in the
internal address bus.
• BARC
Bit Bit Name
Initial
Value
R/W Description
7 to 1 A7 to A1 All 0 R/W Addresses 7 to 1
The A7 to A1 bits are compared with A7 to A1 in the
internal address bus.
0 ⎯ 0 R Reserved
This bit is always read as 0 and cannot be modified.