Datasheet

Section 20 Serial Communication Interface 3 (SCI3, IrDA)
Page 708 of 982 REJ09B0465-0300 Rev. 3.00
Sep 17, 2010
H8S/20103, H8S/20203, H8S/20223, H8S/20115, H8S/20215, H8S/20235 Group
No
<End>
Yes
Start transmission
Read TDRE flag in SSR[1]
Write transmit data to TDR
No
Yes
No
Yes
Read TEND flag in SSR
[2]
Clear TE bit in SCR3 to 0
TDRE = 1
Is data transmission continued?
TEND = 1
[1] Read SSR and check that the TDRE flag is
set to 1, then write transmit data to TDR.
When data is written to TDR, the TDRE flag
is automatically cleared to 0 and clocks are
output to start the data transmission.
If data is transferred to TDR by the DTC
with a transmit data empty interrupt (TXI)
request, the TDRE flag is automatically
checked and cleared.
[2] To continue data transmission, be sure to
read 1 from the TDRE flag to confirm that
writing is possible, then write data to TDR.
When data is written to TDR, the TDRE flag
is automatically cleared to 0.
Figure 20.11 Sample Flowchart for Data Transmission (Clocked Synchronous Mode)