Datasheet

Section 4 Interrupt Controller
Page 106 of 982 REJ09B0465-0300 Rev. 3.00
Sep 17, 2010
H8S/20103, H8S/20203, H8S/20223, H8S/20115, H8S/20215, H8S/20235 Group
4.6.2 Instructions that Disable Interrupts
Instructions that disable interrupts are LDC, ANDC, ORC, and XORC. After any of these
instructions is executed, all interrupts including NMI are disabled and the next instruction is
always executed. When the I bit is set by one of these instructions, the new value becomes valid
after two states that execution of the instruction ends.
4.6.3 Time when Interrupts are Disabled
There are time when interrupt acceptance is disabled by the interrupt controller. The interrupt
controller disables interrupt acceptance for a 3-state period after the CPU has updated the mask
level with an LDC, ANDC, ORC, or XORC instruction.
4.6.4 Interrupts during Execution of EEPMOV Instruction
Interrupt operation differs between the EEPMOV.B instruction and the EEPMOV.W instruction.
With the EEPMOV.B instruction, an interrupt request (including NMI) issued during the transfer
is not accepted until the transfer is completed.
With the EEPMOV.W instruction, if an interrupt request is issued during the transfer, interrupt
exception handling starts at a break in the transfer cycle. The PC value saved on the stack in this
case is the address of the next instruction. Therefore, if an interrupt is generated during execution
of an EEPMOV.W instruction, the following coding should be used.
L1: EEPMOV.W
MOV.W R4,R4
BNE L1