Instruction manual

R8A66597 USB Evaluation Board R0K866597D020BR
Hardware Instruction Manual
R19AN0005EJ0100 Rev.1.00 Page 20 of 26
Jan 10, 2012
How to use the R0K866597D020BR with the RSK is shown as below.
(1) Setting of switch and jumper.
(a) Set JP4 to "3.3 V". ("3.3V" is factory setting)
(b) Set JP7 to "IRQ 0". ("IRQ 0" is factory setting)
(c) Set JP8 to "CSa". ("CSa" is factory setting)
(d) Set JP10 to "EXT". ("EXT" is factory setting)
(2) Connecting the R0K866597D020BR to the RSK.
Insert JA1’s #1-pin and #2-pin of the R0K866597D020BR board to JA1's #1-pin and #2-pin of the RSK to connect
the two boards together.
(3) VBUS output for host function
Apply 5V to CN4 of the R0K866597D020BR board using the power supply cable included. The red wire is 5V and
the black one is GND.
(a) When output VBUS to CN1:
(i) Set high level output to VBOUT0 pin of the R8A66597 by software.
(ii) Set JP6 to "HOST".
(b) When output VBUS to CN5:
(i) Set high level output to VBOUT1 pin of the R8A66597 by software.
It is possible to operate the R8A66597FP using the remote debugger RSK that is attached to the RSK. Please refer to
the RSK's Instruction Manual“.